My hydraulic pump was working fine and now all of the sudden it seems to have quit. What's wrong?

      If your pump seems like it just quit working, or is only working in one direction, check to be sure that the coupler fitting is all the way tight. This fitting sometimes works it's way loose and affects the flow. Be sure all the pressure is released before checking.

What is the PSI of the hydraulic pump?

    The air Hydraulic pumps #900-504-6, 900-504-10 & 900-504-20 are rated at 10,000PSI.

    The Electric Hydraulic Pump #900-508-6 is also rated at 10,000PSI.

What is the finished size of the hole after flaring?

AUTOMOTIVE = The total hole clearance after the punch/flare is made will be 1/8” larger than the punch size i.e.: 1” OD punch will enlarge to 1-1/8” OD after punch/flare.

AIRCRAFT = The total hole clearance after the punch/flare is made will be 1/16” larger than punch size i.e.: 1”OD punch will enlarge to 1-1/16” OD after punch/flare.

What is difference between Automotive & Aircraft Punch & Flares?

What are the Flare dimensions?

Click Drawing for Larger View

What size is the draw bolt for the Punch & Flare tools?

    All Punch & Flare Tools ( Aircraft, Automotive & Punch / Bead) use a 1/2" Diameter draw bolt.

    All Flare Tools use a 3/8" Diameter draw bolt.

What is the difference between the Standard Vise & the Upgrade Vise?

What is the Adjustable Height Vise?

This is a very worthwhile upgrade if you do a lot of notching that requires a  flush fit on one side. Floor pans on race cars are a good example.  No more sticking shims under the tube and guessing if it's going to be right. This vise has graduated markings and a pointer so you can get the right setup each time.

Click For Picture Larger View

What are the bending capacities of the 180° and / or the 90° hydraulic bender?

Copyright 2003 - 2008.  Mittler Brothers Machine and Tool.  All Rights Reserved.  If you have questions or comments, e-mail

sales@mittlerbros.com

Revised: December 31, 2007